Weigh Count Systems - click here
DC150


 

Laser & CCD Scanners - click here


 

FX1 Parallel Beam Systems - click here


 

Bandolier / Surface Mount Count Systems - click here

SMD2000


 

Taping & Reeling Systems - click here

SMHT1100



Weigh Count Systems - click here


GSC9700



Bandolier / Surface Mount Count Systems - click here

SMD1316


KFC Company
PO Box 55
Cinderford
Gloucestershire
GL14 3YB



Office: (01594) 822025


Mobile: 07714 210345


Fax: (01594) 822195


Email us:
info@kfcco.com
 
 
 
 
 
 
 
 
 
 

Welcome Sales Section Hire Section

 

Back SMD2000 Spec SMD1316 Spec B530 Spec

B530
Specification – Model B530 – Bandolier Counter
Description: The Kwickcount was developed to satisfy the need for a Universal Bandolier Counter that is really portable and able to accommodate all axial and radial components in common use.

 Controls:

ON/OFF ZERO SWITCH

Single momentary push-button switch switches the unit on and zeros the reading. The unit will normally switch off 2-3 minutes after the last count has been taken. 

If for any reason there is a need to retain the count, then this may easily be accomplished by placing a piece of card such that it interrupts the optical path – this action will override the automatic switch off facility.

LED INDICATORS (fitted in Bezel)

The switch bezel is fitted with two LED indicators. The left hand one indicates battery condition - when it is ON it indicates the need to charge the batteries. The right hand LED is used in conjunction with the division facility, indicating a valid/invalid count condition.

A valid count is indicated when the lamp is OFF.  Thus, when it is ON it indicates that the count of a Multi-legged component has NOT been completed.

LEFT/RIGHT Switch (fitted on rear panel)

This switch allows you to count Components either increasing from LEFT to RIGHT or by operation of switch – from RIGHT to LEFT(orientation).

This is useful in a stocktaking situation, when complete Reels of components are being counted and a reeler is being used.

Radial Counting: A sixteen way division on the rear of the unit allows for division by 1 through 16. For Axial components this would normally be set to: 10 to extend count to 99,999 without loss of accuracy. With radial components, the division switch is set to correspond to the number of legs, normally 1 – 4.

Battery Charging: 1. Plug the 2.5mm plug on your mains Adaptor Charger into the Jack socket on the rear panel of the counter. Ensure the plug goes well home.

2. Plug the Mains/Adaptor Charger into a convenient 13A outlet.  Switch on.

3. It is possible to use the unit in a purely mains’ situation by use of the mains Adaptor supplied.

 

  • Specification subject to change without notice.


Email now for further information on these products:
sales@kfcco.com

 

 

HOME  SALES:Weigh Count Systems  SALES:Laser & CCD Scanners  SALES:FX1 Parallel Beam Systems  SALES:Bandolier / Surface Mount Count Systems  SALES:Taping & Reeling Systems  HIRE:Weigh Count Systems  HIRE:Bandolier / Surface Mount Count Systems